ATV
-
Roll Pin Punch Tool
Working on your front differential can be a real pain without the correct tools. Get the job done fast and correctly using this roll pin punch tool by Quad Logic. We developed this tool to remove the Pin Spring (Roll Pin) that you see on most of Polaris’s drive train. You can use an air hammer if you have one or just use a normal hammer. Be sure to use a new one each time you remove the old one. Works with the following models and more:
Polaris ATV’s from 1993 to Current
Polaris RZR UTV’s from 2008 to Current
Polaris Ranger UTV’s from 2003 to Current
$24.95$22.46Roll Pin Punch Tool
$24.95$22.46 -
Sportsman (1989-98) Spark Plug NGK BR8ES
A misfiring engine or loss of spark could simply be a bad spark plug. Replace it quickly and easily with this spark plug you would find at the dealer but not paying the extra cost. Genuine NGK BR8ES spark plug. Replaces Polaris part number 3070156. Sold EACH. Fits the following models listed below.
1993 250
1994-95 300
1993 350L
1994-95 400L
1989-92 Big Boss
1997 Big Boss 400L 6×6
1994-97 Sport 400L
1993-96 Sportsman 4×4
1997 Sportsman 400L
REPLACES POLARIS PART NUMBER(S): 3070156$8.95$8.06Sportsman (1989-98) Spark Plug NGK BR8ES
$8.95$8.06 -
Sportsman 400 (1993-1997) Lower Engine Radiator Cooling Hose
We have developed our own line of replacement radiator hoses for Polaris ATV’s! These fabric reinforced hoses are custom formed and automotive quality. These are an exact replacement to the expensive OEM hoses. If you have any bulges or soft spots in your hoses, replace them now before they split. Replaces Polaris part number 5411173 lower radiator hose for the 1993-1997 Sportsman 400’s.
FITS THE FOLLOWING MODEL(S):
1993-’96 SPORTSMAN 400 1997 SPORTSMAN 400L ALSO FITS…
1996-’98 SPORT 400L 1995-’97 SCRAMBLER 400L
REPLACES POLARIS PART NUMBER(S): 5411173 and 5410572Shipping from Ramsey, Minnesota (USA) within 24 hours allows you to BUY WITH CONFIDENCE!
$29.95$26.96 -
Sportsman 400 (1993-1997) Upper Engine Radiator Cooling Hose
We have developed our own line of replacement radiator hoses for Polaris ATV’s! These fabric reinforced hoses are custom formed and automotive quality. These are an exact replacement to the expensive OEM hoses. If you have any bulges or soft spots in your hoses, replace them now before they split. Replaces Polaris part number 5410570 for the 1993-1997 Sportsman 400’s,
FITS THE FOLLOWING MODEL(S):
1993-’96 SPORTSMAN 400 1997 SPORTSMAN 400L ALSO FITS…
1995-’00 SCRAMBLER 400 REPLACES POLARIS PART NUMBER(S): 5410570
Shipping from Ramsey, Minnesota (USA) within 24 hours allows you to BUY WITH CONFIDENCE!
$24.95$22.46 -
Sportsman 400 10″ Battery Strap
Replace your snapped or worn out battery strap with our 10″ battery strap with hooks.
FITS THE FOLLOWING MODELS:
2001-’05 SPORTSMAN 400 2011-’14 SPORTSMAN 400 1993-’96 SPORTSMAN 400L ALSO FITS POLARIS MODELS:
2015 SPORTSMAN ETX 1999-’00 SPORTSMAN 335 REPLACES POLARIS PART NUMBER(S): 5410424 and 5412499
$10.95$9.86Sportsman 400 10″ Battery Strap
$10.95$9.86 -
Sportsman 400 Ignition Switch Keyswitch Key
Stop Letting the dealer rip you off! This is the same exact key switch you would get at the dealer for a fraction of the price. Snaps right in. Two keys and mounting nut included. Replaces part numbers: 4110086 and 4110140
1993-95 2501989-92 Trail Boss 2501994-95 3001993 350L1990-92 Trail Boss 350L1994-95 400L1995 Scrambler 4001994-95 Sport 4001993-95 Sportsman 4001995 Xplorer 400Replacement for the Polaris 4110086 and 4110140
$19.95$17.96Sportsman 400 Ignition Switch Keyswitch Key
$19.95$17.96 -
Sportsman 400 Radiator Hose
We have developed our own line of replacement radiator hoses for Polaris ATV’s! These fabric reinforced hoses are custom formed and automotive quality. These are an exact replacement to the expensive OEM hoses. If you have any bulges or soft spots in your hoses, replace them now before they split. This short hose runs from the water pump to the cylinder on the engine. Hose is about 3 3/8″ in length.
FITS THE FOLLOWING MODEL(S):
1993-’96 SPORTSMAN 400 1997 SPORTSMAN 400L 1994-’99 SPORT 400L ALSO FITS…
1995-’02 SCRAMBLER 400 REPLACES POLARIS PART NUMBER(S): 3084190 and 3086773
$9.95$8.96Sportsman 400 Radiator Hose
$9.95$8.96 -
Sportsman 400 Throttle Cable
NEW Sportsman 400 Throttle Cable! This new 65″ complete throttle cable assembly with a heavy vinyl housing will install and work just like stock. Replaces Polaris part numbers 7080397 and 7080532.
FITS THE FOLLOWING MODEL(S):
1993-’97 SPORTSMAN 400 1997 SPORTSMAN 400L ALSO FITS…1994-’95 400L 1992 BIG BOSS 250 1993 BIG BOSS 350L 1994-’97 BIG BOSS 400L 1994-’95 SPORT 400L 1990-’93 TRAIL BOSS 350L REPLACES POLARIS PART NUMBER(S): 7080397 and 7080532
$24.95$22.46Sportsman 400 Throttle Cable
$24.95$22.46 -
Sportsman 400L 500 1/2″ Rear Wheel Stud (SET OF 4)
Brand new 1/2″ REAR wheel stud for many 1990-2013 Polaris ATV’s and UTV’s with steel wheels. Fits the rear hubs only. Exact replacement for Polaris 7512673. This auction is for a set of FOUR studs. Some applications include:
1993-99 Sportsman 400L
2000-08 Sportsman 500 6×6
Replaces Polaris Part Number 7512673
$11.95$10.76Sportsman 400L 500 1/2″ Rear Wheel Stud (SET OF 4)
$11.95$10.76 -
Sportsman 400L Fuel Tank Cap with Gauge
Know if it is time to fill up with the replacement fuel tank cap with gauge from Quad Logic! This replacement fuel cap will work on your Polaris Sportsman , Magnum, Trail Blazer as well as other later Polaris models.
Fits the following models:
1993-’97 Sportsman 400L 4×4
Replaces Polaris part number 2873626, 2871442 and 2511222.
$19.95$17.96Sportsman 400L Fuel Tank Cap with Gauge
$19.95$17.96 -
Sportsman 400L Water Pump Seal
We developed these seals to be exact replacements to the original. This water pump seal is the INNER of the two water pump seals. Replaces Polaris part # 3084184. Fits the following models and more:
1995-02 Scrambler 400
1994-98 Sport 400
1995-02 Xplorer 400
1996-97 Xpress 300/400
1990-95 Trail Boss 350L
1993-97 Sportsman 400L
1995-97 Big Boss 400L
Replaces Polaris part #3084184.
$11.95$10.76Sportsman 400L Water Pump Seal
$11.95$10.76 -
Sportsman 500 Front Ball Joint Puller Removal Tool
Pulling the ball joints from the aluminum strut housing on most Polaris ATV’s can be a real challenge. We developed this unique tool to make the job much easier. This two piece steel puller simply goes over the balljoint, install the nut, and turn out the inner puller to remove the ball joint. A 6 point 1″ socket is required. Zinc plated for corrosion resistance. The heavy duty design is suited for either home or professional shop use.
Unlike other tools on the market that use all of the old ball joints threads, this tool only uses the top few threads of the ball joint. If your threads are damaged, those other pullers will not work! Even in your threads are damaged you can normally still make our puller work due to the dual puller design. Does the balljoint spin freely or slop up and down in its housing? No problem, this puller will easily remove it! Complete instructions are included.
This puller can be used on almost any Polaris ATV or UTV with the strut style front suspension from about 1985 to current.
You can view a video of the puller in action on Youtube here, just copy and past the URL into your browser:
https://youtu.be/NgGPTWaG5Q0
$39.95$35.96Sportsman 500 Front Ball Joint Puller Removal Tool
$39.95$35.96 -
Sportsman 500 Primary Clutch Weight Bolt and Nut Kit
Brand new primary clutch weight shoulder bolt and nut kit for many older Polaris ATV’s. Brand new high quality parts are exactly the same as the originals! These replace Polaris part numbers 7512266 and 7541906. Includes three bolt’s and three nut’s. Fits the following models and more:
1994-98 Sport 400L
1993-96 Sportsman
1999-00 Sportsman 335
1997 Sportsman 400L
2001-05 Sportsman 400
2006 Sportsman 450
1996-07 Sportsman 500
Replaces Polaris Part Number: 7512266 and 7541906
$19.95$17.96Sportsman 500 Primary Clutch Weight Bolt and Nut Kit
$19.95$17.96 -
Trail Blazer 250 (1990-2006) Carburetor Intake Adapter Boot
Brand new intake manifold for the Polaris Trail Blazer 250 motors. A cracked or leaking intake manifold will cause a lean condition and engine damage if not corrected. Get it back running like new again with this new direct replacement intake boot by Quad Logic.
FITS THE FOLLOWING MODEL(S):1990-’06 TRAIL BLAZER 250 1993 250 1994-’95 300 1989-’92 BIG BOSS 250 1985-’86 SCRAMBLER 250 1996-’97 SPORT 400L 1985-’99 TRAIL BOSS 250 1996-’02 XPLORER 300 1996-’99 XPRESS 300 1996-’97 XPRESS 400 USED ON CAN-AM PART NUMBER(S): 3085013 and 3083412
$17.95$16.16 -
Trail Blazer 250 Complete Engine Gasket Set with Seals
Trail Blazer 250 Complete Engine Gasket Set with Seals includes all the gaskets and seals to completely rebuild the engine of your Polaris 250 two stroke. Don’t ever re-use old gaskets when rebuilding your engine! High quality non-asbestos materials are used in kit. Includes all of the following gaskets and seals shown in the photo including:
- Head Gasket
- Base Gasket
- Intake Boot O-ring
- Exhaust Gasket
- Starter Gasket
- PTO Oil Seal
- Mag Oil Seal
This gasket kit fits the following models:
1990-2006 Trailblazer 250
1989-92 Trailboss 250
1989-92 Big Boss 250
2000-02 Xplorer 250
We make every attempt to ensure every items fitment is accurate. We do the testing on each item before its listed for sale to ensure fitment and quality. Items may fit multiple years and models listed.$24.95$22.46Trail Blazer 250 Complete Engine Gasket Set with Seals
$24.95$22.46 -
Trail Blazer 250 Magneto Stator
Complete replacement stator for your Polaris ATV. All stators are brand new and are ready to plug right in. These are tested before they are shipped so you know you will not get a defective unit right out of the box. They use the highest quality windings and lamination material. Replaces Polaris part # 3083979. Fits following models listed below.
1990-2006 Trail Blazer 250
Replaces Polaris Part Number: 3083979
$199.95$179.96Trail Blazer 250 Magneto Stator
$199.95$179.96