| | |
 | Spark Plug Caddy(Reference #131-100)
This spark plug case holds 2 14mm spark plugs and is small enough to fit in your pocket
0 In Stock
$1.60
|
| |
|
 | Spark Plug Jack(Reference #PLUGJACK)
This plug jack rivets or screws to any flat surface and holds 2 or 3 14mm spark plugs. Tough polycarbonate plastic construction with spring loaded plug anchors keep plugs dry and gaps stay set until ready for use.
|
| |
Spark Plug Jack
(Reference #131-150)
$2.49 | 2 PLUG JACK
11 In Stock
| |
Spark Plug Jack
(Reference #131-160)
$6.50 | 3 PLUG JACK
8 In Stock
| |
|
Spark Plug Wire(Reference #164-932)
Neoprene spark plug cap with 18" Hypalon x 7mm diameter wire.
3 In Stock
$3.25
|
|
|
Spark Plug Connector(Reference #164-906)
Genuine NGK resistor spark plug connector. 5000 OHM resistance. Same connector as used by most manufacturers. For use with 14mm plugs with terminal nut on. Plastic body. Sold individually.
35 In Stock
$2.45
|  |
| |
|
Spark Plug Connector(Reference #PLUGCONN)
Rubber body.
Available in black or green.
Sold individually
|  |
| |
Spark Plug Connector
(Reference #164-908)
$5.75 | BLACK
14 In Stock
| |
Spark Plug Connector
(Reference #1639-620)
$5.95 | GREEN
0 In Stock
| |
|
Neoprene spark plug cap with spring connector(Reference #164-901)
$1.20
8 In Stock |
|
Sold individually
|
|
 | Spark Plug Wrench(Reference #725-780)
14mm
0 In Stock
$3.95
|
| |
|
Spark Plug Holder(Reference #131-101)
We absolutely guarantee the man of the house cannot have too many plug protectors - these make great stocking stuffers. Inexpensive holder will protect plug's electrode, proper gap and ceramic body under the most severe bouncing in sled, bike and atv storage compartments. Delivers fresh plugs in all conditions. 2 pack.
83 In Stock
$2.49
|  |
| |
|
 | Spark Plug Indexing Washers(Reference #245INDEX)
Have you ever noticed when removing your spark plugs that one side of the tip is burning lean while the other side appears to be rich. Here's why…take a look at your transfer ports, they are all directed to pack the charge on the intake side of your cylinder. When you index your plugs you are aligning the open end of your electrode on your spark plug toward the intake port of your cylinder by using certain thicknesses of washers to achieve this. Gain performance, fuel mileage and plug life. Kit contains sets of 4 different thickness washers and complete instructions. Available for 2 and 3 cylinder - make your choice below.
Installation Instructions
|
| |
Indexing Washers
(Reference #245-500)
$9.95 | TWIN CYLINDER
13 In Stock
| |
Indexing Washers
(Reference #245-510)
$14.95 | THREE CYLINDER
15 In Stock
| |
