ATV Engine Accessories | Offset Ignition Key | KN PowerLid | Intake Kits

ATV Product Catalog

ATV Parts Catalog > ATV Engine Accessories


	Polaris Offset Ignition Key Ref: ATV-OFFSETKEY Advance the timing curve for up to 2 hp gain More advance may raise engine temp. Watch piston & plug reading or EGT and compensate accordingly Better throttle response, mid-range and top end Replaces stock OEM #7721117 Works great in 6/7/8 Sportsman ATV's and 700 EFI Rangers

ATV Offset Key Ref: 201-706 $19.95	1.5 Degree 0 In Stock	CURRENTLY OUT OF STOCK
ATV Offset Key Ref: 201-707 $19.95	2.5 Degree 0 In Stock	CURRENTLY OUT OF STOCK
ATV Offset Key Ref: 201-708 $19.95	3.5 Degree 7 In Stock

	K&N PowerLid Ref: KN-POWERLID Replaces stock air box lid. Snaps in place with no air box modification needed. Increases air flow while maintaining stock air box. Designed to increase horsepower and throttle response. Eliminates restrictive intake snorkels. Carburetor jet selection kit included if required. Washable and reusable K&N filter element Dyno tested NOTE: The K&N PowerLid is desinged for air flow management only. Do not use without the primary air filter fitted to the intake system. Not intended for use in water or muddy conditions.

K&N PowerLid Ref: HA-4099-T -HONDA TRX400EX 1999-06 1 In Stock $116.95
K&N PowerLid Ref: HA-4504-T -HONDA TRX4050R 2004-05 1 In Stock $134.95
K&N PowerLid Ref: SU-4002-T -KAWASAKI KFX400 2003-06 and -SUZUKI Z400 Quadsport 2003-06 1 In Stock $98.95
K&N PowerLid Ref: YA-6601-T -YAMAHA YFM660 Raptor 2001-05 1 In Stock $113.95
K&N PowerLid Ref: YA-3502-T -YAMAHA YFZ350 Banshee 1987-06 1 In Stock $116.95
K&N PowerLid Ref: YA-4504-T -YAMAHA YFZ450 2004-06 1 In Stock $101.95

Flow-Rite Intake Kits Ref: 14-FLOWRITE Eliminate air intake restrictions by installing the Flow-Rite in the dash or intake tract for more air box feed. The Flow-Rite is supplied with a powder snow pre-filter that repels snow and water, yet passes air right through. Sold individually. These 2 are made using a rubber flange to attach the Flow-Rite to the surface that it is being installed in. This rubber flange conforms itself to a wide variety of contoured, shaped and textured surfaces for a universal mounting system.

Flow-Rite Intake Kit Ref: 14-189 2 1/2" ID x 3 5/8" OD (Required Hole Size = 3 1/8") 35 In Stock $20.95
Flow-Rite Intake Kit Ref: 14-194 2" ID x 2 11/16" OD (Required Hole Size = 2 3/8") 13 In Stock $20.95

	Flow-Rite Intake Kit Ref: 14-197 Same as Flow-Rite Intake Kit above except this one is designed for ease of installation on flat or nearly flat surfaces. It requires a 2 1/2" size hole saw which is readily available from any hardware store. Installatin is a snap: hole saw the hole (2 1/2" hole required), debur the edges, clean hole saw shavings and snap Flow-Rite into place. 2" ID x 2 3/4" OD. Sold individually. 3 In Stock $20.95


PowAir^TM Intake Vents Ref: POWAIR-VENT Low cost design for a cheaper alternative to the competition 100% digestable materials Intake screen for debris protection Plastic construction prohibits icing and sticking Easy hole-saw installation Extremely low cracking pressure ensures the engine does not bog The 3 inch vent has nearly 2x the flow volume as the competition (the 2 inch is comparable)

PowAir Vent Ref: 201227 $10.95	2" Vent 15 In Stock
PowAir Vent Ref: 201228 $13.95	3" Vent 12 In Stock

	TPI Valve Low Boy Ref: LOWBOY The TPI Valve is designed to increase air flow into your air box and carburetors. This is one of the fastest and easiest ways to increase performance. The patent pending TPI Valve is totally adjustable, allowing you to determine exactly how much to increase air flow. We call this "air jetting". Air passing through the TPI Valve is filtered by an internal filter in the TPI Valve. Easy to use and install, the Low Boy is 2 5/8" square and mounts flush on the airbox. One valve recommended per 200cc. Sold individually.

Low Boy Ref: 201-215 $18.95	BLACK 6 In Stock

	BullsEye Air Intakes Ref: 201-224 D&D's Bullseye Air Intakes are great for any air box; snowmobile or ATV. The principle is simple: more air = more power. Just drill a 1 1/2" hole and press in for more air flow. In most cases, adding performance parts such as pipes, reeds or big bores makes the stock air box insufficient. By adding the Bullseye Air Intakes, you can greatly improve air flow. The intakes come in a package of six. Available in black only. 9 In Stock $40.95


Three Bond Liquid Gasket Ref: 265-191 ThreeBond 1194 is a semidrying liquid gasket whose major component is special synthetic rubber. After it is applied and dried, it will form a rubber-like elastic body. Since it excels in padding property, it shows a high sealing effect on bonded surfaces that have poor flatness and large clearance. In addition, it has excellent resistance to water, oil and gasoline. 63 In Stock $9.95